Knowledge Base
AVM Content
To the knowledge base
Knowledge document #108
FRITZ!Box 6490 Cable
This support document is available for the following products:
- FRITZ!Box 7690
- FRITZ!Box 7590 AX
- FRITZ!Box 7590
- FRITZ!Box 7583 VDSL
- FRITZ!Box 7583
- FRITZ!Box 7582
- FRITZ!Box 7581
- FRITZ!Box 7560
- FRITZ!Box 7530 AX
- FRITZ!Box 7530
- FRITZ!Box 7520
- FRITZ!Box 7510
- FRITZ!Box 7490
- FRITZ!Box 7430
- FRITZ!Box 7390
- FRITZ!Box 7360
Setting up an external fax in the FRITZ!Box
You can use a fax machine connected to an analog extension or the "FON S0" socket of your FRITZ!Box to send and receive faxes over the internet.
1 Enabling fax transmission with T.38
If you use an internet telephone number for faxing, you must enable T.38 (fax over IP) in the FRITZ!Box for fax transmission. With T.38, a special network protocol is used for fax transmission instead of signal tones. This makes transmission significantly less susceptible to interference:
- Click "Telephony" in the FRITZ!Box user interface.
- Click "Telephone Numbers" in the "Telephony" menu.
- Click on the "Line Settings" tab. If the tab is not displayed, your cable provider automatically configures the line settings during configuration. You cannot change these settings later. Your cable provider can provide you with information on the settings.
- Click "Changing the Settings" in the "Telephony connection" section.
- Enable the option "Fax transmission using T.38".
- Click "Apply" to save the settings.
2 Reconfiguring the fax machine
Set up the fax machine in the FRITZ!Box, even if it is connected to the FRITZ!Box via an ISDN telephone system:
- Click "Telephony" in the FRITZ!Box user interface.
- Click "Telephony Devices" in the "Telephony" menu.
- If the fax machine already exists in the list of telephony devices, click the (Delete) button for the fax machine.
- Reconfigure the fax machine: Click the "Configure New Device" button and follow the instructions.
- If you cannot select the socket the fax machine is connected to when configuring it, another telephony device was already configured for that socket. Delete that device.
- If the fax machine is connected to the "FON S0" socket on the FRITZ!Box, during setup you will be shown which telephone numbers to assign to the fax machine. If the fax machine is connected via an ISDN telephone system, you must assign the telephone numbers to the port on the ISDN telephone system that the fax machine is connected to.