Recommend:
To the knowledge base
Knowledge document #3275
FRITZ!Smart Gateway
This support document is available for the following products:

Loading the factory settings of the FRITZ!DECT radiator control

Load the factory settings to delete all of the individual settings you have made for the FRITZ!DECT radiator control. This makes sense if you are going to use the FRITZ!DECT radiator control at a different location or are planning to pass it on to another user, for example.

You can use the Menu button to load the factory settings of the FRITZ!DECT radiator control, for example FRITZ!DECT 302.

1 Deregistering the FRITZ!DECT radiator control

  1. Click "Smart Home" in the user interface of the FRITZ!Smart Gateway.
  2. Click "Devices and Groups" in the "Smart Home" menu.
  3. Click the "Delete Device" button.
  4. Afterwards, click the (Delete) button next to the respective device.
  5. Click the "Finished" button.

2 Restart the FRITZ!Smart Gateway

Some of the radiator control's settings may remain in the FRITZ!Smart Gateway after it has been deregistered. Therefore, restart the FRITZ!Smart Gateway to delete all of the settings:

  1. Click "System" in the user interface of the FRITZ!Smart Gateway.
  2. Click "Backup" in the "System" menu.
  3. Click on the "Restart" tab.
  4. Click the "Restart" button.

3 Loading the factory settings

  1. Push the "Menu" button on the radiator control. With FRITZ!DECT 302, hold the button down for at least 2 seconds.
  2. If available, push (next menu page).
  3. Push (load factory settings) or select the menu item "Zurücksetzen" or "RES".
  4. Push "OK".
  5. Push "OK" again, if you are asked to do so.
Language selection