Knowledge Base
AVM Content
Knowledge document #3507
FRITZ!Repeater 3000 AX
This support document is available for the following products:
FRITZ!Repeater only connects to FRITZ!Box over 2.4 GHz
The FRITZ!Repeater only uses the 2.4 GHz Wi-Fi network to establish the Wi-Fi connection to the FRITZ!Box although the 5 GHz Wi-Fi network is enabled in the FRITZ!Box.
Work through the following steps to resolve the problem.
1 Disabling the FRITZ!Box's MAC address filter
Disable the FRITZ!Box's MAC address filter for the duration of the setup because otherwise the FRITZ!Repeater cannot connect to the 5 GHz Wi-Fi network using WPS during setup:
- Click "Wi-Fi" ("Wireless") in the FRITZ!Box user interface.
- Click "Security" or "Radio Network" in the "Wi-Fi" menu.
- If available, click "Restrict Access to Wi-Fi".
- Enable the option "Allow all new wireless devices". If the option is not displayed, enable the Advanced View first.
- Click "Apply" to save the settings.
2 Checking whether radar detection is enabled
The FRITZ!Box must locate radar systems and, in certain situations, comply with the DFS wait time required by law. During this wait time, wireless devices cannot connect to the 5 GHz Wi-Fi network. Therefore, check whether radar detection is active before reconnecting the FRITZ!Repeater with the FRITZ!Box:
- Click "Wi-Fi" ("Wireless") in the FRITZ!Box user interface.
- Click "Wi-Fi Channel" ("Radio Channel") in the "Wi-Fi" ("Wireless") menu.
- Click on the "5-GHz Band" tab in the section "Wi-Fi Environment".
- Check whether the message "Radar detection enabled. At the moment no Wi-Fi connection (5 GHz) is possible; please wait" is displayed in the diagrams in the section "Wi-Fi Environment".
- If the message is not displayed, continue with the next section.
- If the message is displayed, wait until radar detection is complete before proceeding with the following section.
3 Reconnecting FRITZ!Repeater with the FRITZ!Box
- Push and hold down the Connect button on the FRITZ!Repeater for about 6 seconds until the Connect LED flashes.
- Within 2 minutes: Push and hold down the Connect button on the FRITZ!Box until the Connect LED (see table) lights up. Other LEDs may also light up:
FRITZ!Box model Connect button Connect LED FRITZ!Box 6690, 5690, 4060 Connect Connect FRITZ!Box 7690, 7590 (AX), 7530 (AX), 7520, 7510, 6890, 6850, 6670, 6660, 5590, 5530 Connect / WPS Connect / WPS FRITZ!Box 6591, 6590 Connect / WPS WLAN / DECT FRITZ!Box 7490, 7430, 5491, 5490 WLAN WPS WLAN / Info FRITZ!Box 6490, 6430 WLAN WPS WLAN / DECT FRITZ!Box 7560, 7362 SL WLAN WLAN / DECT FRITZ!Box 7583, 7582, 7581, 7580 WPS WLAN / Info FRITZ!Box 6820, 4040, 4020, 3490 WPS WLAN - The LED for connection quality lights up as soon as the Wi-Fi connection is established.