Recommend:
To the knowledge base
Knowledge document #3465
FRITZ!Powerline 1240E
This support document is available for the following products:

Since updating FRITZ!OS, FRITZ!Powerline no longer works

Since updating FRITZ!OS manually or automatically, the FRITZ!Powerline device no longer works. One or several LEDs on the device flash continuously or all LEDs are off. The update failed.

Simply proceed as described below. After each measure, check whether the problem is solved.

1 Restarting the FRITZ!Powerline device

  1. Unplug the FRITZ!Powerline device.
  2. Plug the FRITZ!Powerline device back in after about 1 minute.

    Note:Restarting the FRITZ!Powerline device will not delete any of the settings.

2 Loading the factory settings by button

  1. Plug the FRITZ!Powerline device into an electrical outlet and wait about 1 minute until the FRITZ!Powerline device has restarted completely.
  2. Push the corresponding button on the device:
    ModelButtonDuration
    FRITZ!Powerline 1260(E) / 1240 AX Connect 15 seconds
    FRITZ!Powerline 1220 / 1210 Connect 10-15 seconds
    FRITZ!Powerline 1240E WLAN - WPS
    Powerline - Security    		 15 seconds
    FRITZ!Powerline 1220E / 1000E Powerline · Security 10-15 seconds
    FRITZ!Powerline 546E / 540E WLAN · WPS und Powerline · Security 10 seconds
    FRITZ!Powerline 530E / 510E Security 12 seconds
    FRITZ!Powerline 520E / 500E Reset 2 seconds
  3. Wait about 2 minutes until the process is completed.

3 Resetting the FRITZ!Powerline device

  1. Use the recovery program to reset the FRITZ!Powerline device.
Language selection