Recommend:
To the knowledge base
Knowledge document #3422
FRITZ!DECT Repeater 100
This support document is available for the following products:

Adjusting the temperature measured on a FRITZ!DECT Repeater

The temperature measured on the FRITZ!DECT Repeater may differ from the actual room temperature. If the FRITZ!DECT Repeater is next to a heater or behind a curtain, for example, the temperature on the repeater itself is probably higher than the temperature you measure with a thermometer in the middle of the room. You can correct this deviation by positioning the FRITZ!DECT Repeater somewhere more suitable and adjusting the temperature deviation, the so-called offset.

Note:All instructions on configuration and settings given in this guide refer to the latest FRITZ!OS for the FRITZ!Box.

1 Finding the ideal location for the FRITZ!DECT Repeater

  1. Plug FRITZ!DECT Repeater into a wall outlet.
  2. Make sure that the ventilation slots are not covered, the device is not exposed to direct sunlight, and that it is not located directly next to a heater.
  3. Remove any possible sources of heat near the device (for example other electrical devices that radiate heat).

2 Setting the temperature offset

If there is still a difference between the temperature measured and the actual room temperature, you can set the offset:

Important:The temperature at the device itself can vary greatly because of fluctuations due to time of day, for example occasional exposure to sunlight or reduced ventilation, heating up of the device, etc. The deviation between the temperature at the device itself and the actual room temperature is therefore not constant. The offset cannot be used to take variable temperature fluctuations into account. This means that the location is not suitable for accurate temperature readings.

  1. Click "Home Network" or "Smart Home" in the FRITZ!Box user interface.
  2. Click "Smart Home" in the "Home Network" menu or click "Device Management" in the "Smart Home" menu.
  3. Click the (Edit) button for the respective device.
  4. Under "Temperature Offset", set the actual room temperature by clicking the plus or minus.
  5. Click "OK" to save the settings.