Recommend:
To the knowledge base
Knowledge document #3482

Cannot register a FRITZ!DECT smart switch

Registration of the FRITZ!DECT smart switch to the FRITZ!Box fails. After you push the DECT or Connect button on the FRITZ!Box, the DECT connection is not established. The FRITZ!DECT smart plug is not displayed or is displayed with an inactive connection in the menu "Smart Home" in the FRITZ!Box.

Note:All instructions on configuration and settings given in this guide refer to the latest FRITZ!OS for the FRITZ!Box.

Simply proceed as described below. After each measure, check whether the problem is solved.

1 Maximum number has been reached

You can register up to ten FRITZ!DECT smart switches, for example FRITZ!DECT 400, with the FRITZ!Box. If you already registered ten devices, you cannot register any more devices.

2 Unlocking the buttons

  1. Click "System" in the FRITZ!Box user interface.
  2. Click "Buttons and LEDs" in the "System" menu.
  3. Click on the "Keylock" tab.
  4. Disable the "Buttons locked" checkbox.
  5. Click "Apply" to save the settings.

3 Disabling "Reduce DECT field strength"

  1. Click "DECT" in the FRITZ!Box user interface.
  2. Click "Base Station" in the "DECT" menu.
  3. Disable the option "Reduce DECT field strength" in the section "Radio Field Strength".
  4. Click "Apply" to save the settings.

4 Disabling "DECT Eco"

  1. Click "DECT" in the FRITZ!Box user interface.
  2. Click "Base Station" in the "DECT" menu.
  3. Disable the option "DECT Eco" in the section "Radio Field Strength".
  4. Click "Apply" to save the settings.

5 Enabling encryption

  1. Click "DECT" in the FRITZ!Box user interface.
  2. Click "Base Station" in the "DECT" menu.
  3. Enable the option "Permit only secure DECT connections (recommended)" in the section "Security".
  4. Click "Apply" to save the settings.
  5. If the option was disabled, you must then restart the FRITZ!Box once using the user interface ("System > Backup > Restart").

6 Setting a PIN

For automatic registration to work, you must set the PIN to "0000" in the FRITZ!Box user interface:

  1. Click "DECT" in the FRITZ!Box user interface.
  2. Click "Base Station" in the "DECT" menu.
  3. Enter "0000" as the PIN in the section "Registration".
  4. Click "Apply" to save the settings.

7 Resetting the FRITZ!DECT smart switch and deregistering it

You can restore factory settings to the FRITZ!DECT smart switch and deregister it. This deletes a faulty connection to the FRITZ!Box and all of the settings that are preventing the connection from being established:

  1. Load the factory settings of the FRITZ!DECT smart switch and deregister it.
Language selection