Knowledge Base
AVM Content
To the knowledge base
Knowledge document #3769
FRITZ!Box 6690 Cable
This support document is available for the following products:
Loading the factory settings of FRITZ!DECT 350
Load the factory settings to reconnect the FRITZ!DECT door/window contact or to connect it with a different FRITZ!Box or FRITZ!Smart Gateway. This makes sense if you are going to use the door/window contact at a different location or are planning to pass it on to another user, for example.
You can easily load the factory settings of the door/window contact using the pin included with delivery.
1 Loading the factory settings
- Open the housing of FRITZ!DECT 350.
- Pick up the pin included with delivery.
- Carefully insert the pin into the "Reset" opening inside the housing for at least one second. The LED inside the sensor begins to flash and the factory settings are loaded.
2 Deregistering the door/window contact
- Click "Smart Home" in the FRITZ!Box user interface.
- Click "Devices and Groups" in the "Smart Home" menu.
- Click the "Delete Device" button.
- Click the (Delete) button next to the respective device.
- Click the "Finished" button.