Recommend:
Knowledge document #3490

Manually connecting the FRITZ!Repeater with the FRITZ!Box home network via Wi-Fi

The FRITZ!Repeater can be integrated into the mesh of the FRITZ!Box quickly and easily at the touch of a button. If you do not want to integrate the repeater into the Mesh, you can also use the configuration wizard to set up the Wi-Fi connection to the FRITZ!Box manually.

Connection scenario for wireless bridge mode

1 Disabling the FRITZ!Box's MAC address filter

When the MAC address filter is enabled, the FRITZ!Repeater cannot connect to the FRITZ!Box. Therefore, make sure that the MAC address filter is disabled:

  1. Click "Wi-Fi" ("Wireless") in the FRITZ!Box user interface.
  2. Click "Security" or "Radio Network" in the "Wi-Fi" menu.
  3. If available, click "Restrict Access to Wi-Fi".
  4. Enable the option "Allow all new wireless devices". If the option is not displayed, enable the Advanced View first.
  5. Click "Apply" to save the settings.

2 Loading the FRITZ!Repeater's factory settings

To perform the following steps, the FRITZ!Repeater must be set to factory settings:

  1. Loading the FRITZ!Repeater's factory settings
    Plug the FRITZ!Repeater in.
  2. Wait about 1 minute until the FRITZ!Repeater starts and the Power and WLAN LEDs remain lit or the LEDs of the signal strength indicator flash.
  3. Push and hold down the WPS button down for about 15 seconds until all of the LEDs flash at the same time.
  4. The Power and WLAN LEDs remain lit as soon as the factory settings have finished loading.

3 Connecting a wireless device with the FRITZ!Repeater

  1. Network key
    Make note of the network key on the back of the FRITZ!Repeater (see fig.). 
  2. For setup, plug the FRITZ!Repeater into a power outlet near the FRITZ!Box.
  3. Wait about 1 minute until the FRITZ!Repeater has started and the Power and WLAN LEDs remain lit.
  4. Search for Wi-Fi networks in the vicinity with a wireless device (for example a notebook, smartphone).
  5. Select the Wi-Fi network "FRITZ!WLAN Repeater DVB-C".
  6. Enter the network key (password) you made note of.

4 Setting up the FRITZ!Repeater as a wireless bridge

  1. Open the user interface of the FRITZ!Repeater.
  2. Set a password to access the user interface, then click "OK" and "Next".
  3. Enable the connection type "Wireless Bridge" and click "Next".
  4. From the list, select the Wi-Fi networks of your FRITZ!Box that you want to extend and click "Next".
  5. Select the encryption type and enter the FRITZ!Box's network key.
  6. Define how the frequency band for the connection between the FRITZ!Repeater and the FRITZ!Box should be selected and click "Next".
  7. Click "Finish" to save the settings.
  8. One or more signal strength LEDs on the FRITZ!Repeater remain lit as soon as setup is completed.

5 Configuring the repeater for television reception

If you want to transmit your cable provider's cable TV content to the home network as an IP stream, configure television reception in the FRITZ!Repeater:

  1. Configure the FRITZ!Repeater for television reception via DVB-C.

6 Finding the ideal location for the FRITZ!Repeater

To extend the range as much as possible, the FRITZ!Repeater requires a fast and stable Wi-Fi connection to the FRITZ!Box:

  1. Position the FRITZ!Repeater so that at least three of its five signal strength LEDs light up. You can find tips on positioning it in the guide Finding the ideal location for FRITZ!Repeater.



Help topics:

Language selection