Knowledge Base
AVM Content
- FRITZ!Box 7682
- FRITZ!Box 7590 AX
- FRITZ!Box 7590
- FRITZ!Box 7583 VDSL
- FRITZ!Box 7583
- FRITZ!Box 7582
- FRITZ!Box 7581
- FRITZ!Box 7560
- FRITZ!Box 7530 AX
- FRITZ!Box 7530
- FRITZ!Box 7520
- FRITZ!Box 7510
- FRITZ!Box 7490
- FRITZ!Box 7430
- FRITZ!Box 7390
- FRITZ!Box 7360
- FRITZ!Box 6890 LTE
- FRITZ!Box 6850 5G
- FRITZ!Box 6850 LTE
- FRITZ!Box 6840 LTE
Constant restarts: Several LEDs on the FRITZ!Box flash
The FRITZ!Box constantly restarts. When this happens, all or several LEDs flash continuously. The FRITZ!Box user interface cannot be opened and either all or individual FRITZ!Box functions do not work properly.
Important:If the FRITZ!Box restarts occasionally, proceed as described in this guide.
Simply proceed as described below. After each measure, check whether the problem is solved.
1 Restarting the FRITZ!Box
- Unplug the FRITZ!Box for 5 minutes.
Note:The FRITZ!Box settings are retained when you unplug it. After you plug the FRITZ!Box in again, it takes about 2 minutes for it to restart. During this time, you cannot access the FRITZ!Box.
2 Using the correct power adapter
Using an unsuitable power adapter for the FRITZ!Box is one of the most common causes of error:
- Use a suitable power adapter to plug in your FRITZ!Box.
3 Testing whether a USB device is interfering
The problem may be caused by a USB device connected to the FRITZ!Box:
- Remove all USB devices from the FRITZ!Box. If the problem no longer occurs then, either a USB device or its cable is faulty, or a device consumes too much power.
- Reconnect the USB devices to the FRITZ!Box one by one to find out which device causes the problem.
- For testing purposes, use a USB hub with its own power adapter (active USB hub) to connect the device causing interference to the FRITZ!Box.
- If the problem also occurs when using it with an active hub, replace the USB device.
4 Resetting the FRITZ!Box
If the problem still occurs, the FRITZ!Box is in an error state:
- Use the recovery program to reset the FRITZ!Box.