Recommend:
To the knowledge base

Connecting a FRITZ!Repeater with the Mesh Repeater via LAN (cascading)

You can cascade several Mesh Repeaters in the Mesh. This type of cascading makes it possible for you to extend your home network in a specific direction beyond the Wi-Fi range of a Mesh Repeater.

This means that not only can you connect your FRITZ!Repeater with the FRITZ!Box (Mesh Master), you can also connect it with an already existing Mesh Repeater. It does not matter whether the existing Mesh Repeater is another FRITZ!Repeater, a FRITZ!Box, or a FRITZ!Powerline device, or whether the Mesh Repeater is connected via LAN or Wi-Fi.

In this guide we show you how to connect your new FRITZ!Repeater with an already existing Mesh Repeater using a network cable.

Example of LAN cascading with two FRITZ!Repeaters

Requirements / Restrictions

  • The existing Mesh Repeater is connected with the Mesh Master and is marked with the Mesh symbol in the Mesh Overview.
  • Both Mesh Repeater have a LAN port.

Note:All instructions on configuration and settings given in this guide refer to the latest FRITZ!OS for the FRITZ!Box.

1 Loading the FRITZ!Repeater's factory settings

To perform the following steps, the FRITZ!Repeater must be set to factory settings:

2 Adding a FRITZ!Repeater to the Mesh by button

You must push a button to add the device to the Mesh. It does not matter whether you push the button on the Mesh Master or the Mesh Repeater first. We recommend the following order:

  1. For setup, position the FRITZ!Repeater near the Mesh Master. If the FRITZ!Repeater is already connected to the home network over LAN, clear that connection.
  2. Wait about 1 minute until the Connect LED on the FRITZ!Repeater flashes more slowly or until the Power LED and the WLAN LED on the FRITZ!Repeater remain lit.
  3. Briefly push the Connect button or WPS button on the FRITZ!Repeater (for about 1 second) and release it again. When you release the button, the Connect LED starts to flash quickly or the WLAN LED starts to flash.
  4. Within 2 minutes: Push and hold down the WPS button on the Mesh Master for about 1 second until the WLAN LED flashes.
  5. The FRITZ!Repeater is fully integrated into the Mesh about 5 seconds after the LED for connection quality glows green or one or more signal strength LEDs on the new FRITZ!Repeater remain lit.

3 Configuring the FRITZ!Repeater as a LAN bridge

  1. Click "Access to Home Network" in the user interface of the FRITZ!Repeater. If you are asked for a password, enter the password for the user interface of the Mesh Master.
  2. Click the "Change the Type of Connection" button in the "Access to Home Network" menu.
  3. Enable the option "LAN bridge" and click "Next".
  4. Select which IP settings the FRITZ!Repeater should use and click "Next".
  5. Keep the Wi-Fi settings displayed for the FRITZ!Repeater and click "Next".
  6. Click "Finish" to save the settings.

4 Connecting the FRITZ!Repeater with the existing Mesh Repeater

  1. Use a network cable to connect the FRITZ!Repeater to a LAN port on the existing Mesh Repeater.