Recommend:
To the knowledge base
Knowledge document #1264
FRITZ!Box 6810 LTE
This support document is available for the following products:

Cannot register a FRITZ!DECT smart plug

Registration of the smart plug, for example FRITZ!DECT 200, fails. After the automatic configuration, the DECT LED flashes continuously and the DECT connection between FRITZ!Box and FRITZ!DECT is not established.

Note:All instructions on configuration and settings given in this guide refer to the latest FRITZ!OS for the FRITZ!Box.

Simply proceed as described below. After each measure, check whether the problem is solved.

1 Maximum number has been reached

You can register up to ten FRITZ!DECT 200s with the FRITZ!Box. If you already registered ten devices, you cannot register any more devices.

Note:Registering a FRITZ!DECT 200 does not reduce the number of telephones or DECT repeaters that can be registered.

2 Unlocking the buttons

  1. Click "System" in the FRITZ!Box user interface.
  2. Click "Buttons and LEDs" in the "System" menu.
  3. Click on the "Keylock" tab.
  4. Disable the "Buttons locked" checkbox.
  5. Click "Apply" to save the settings.

3 Disabling "Reduce DECT field strength"

  1. Click "DECT" in the FRITZ!Box user interface.
  2. Click "Base Station" in the "DECT" menu.
  3. Disable the option "Reduce DECT field strength" in the section "Radio Field Strength".
  4. Click "Apply" to save the settings.

4 Disabling "DECT Eco"

  1. Click "DECT" in the FRITZ!Box user interface.
  2. Click "Base Station" in the "DECT" menu.
  3. Disable the option "DECT Eco" in the section "Radio Field Strength".
  4. Click "Apply" to save the settings.

5 Enabling encryption

  1. Click "DECT" in the FRITZ!Box user interface.
  2. Click "Base Station" in the "DECT" menu.
  3. Enable the option "Permit only secure DECT connections (recommended)" in the section "Security".
  4. Click "Apply" to save the settings.
  5. If the option was disabled, you must then restart the FRITZ!Box once using the user interface ("System > Backup > Restart").

6 Re-registering FRITZ!DECT

Deregistering FRITZ!DECT

  1. Push the DECT button on FRITZ!DECT and hold it down for at least 6 seconds.

The DECT LED starts to flash as soon as the FRITZ!DECT is deregistered.

Restarting the FRITZ!Box

  1. Click "System" in the FRITZ!Box user interface.
  2. Click "Backup" in the "System" menu.
  3. Click on the "Restart" tab.
  4. Click the "Restart" button.

Registering FRITZ!DECT

  1. Plug the FRITZ!DECT into a power outlet near the FRITZ!Box.
  2. Click "Home Network" in the FRITZ!Box user interface.
  3. Click "Smart Home" in the "Home Network" menu.
  4. Click the "Register New Device" button.
  5. Within 2 minutes: Push the DECT button on FRITZ!DECT. Hold down the button for at least 6 seconds until the DECT LED starts to flash quickly. The FRITZ!DECT is in registration mode as long as the LED flashes quickly.

The DECT LED on the FRITZ!DECT remains lit as soon as the DECT connection has been established. Then you can plug the FRITZ!DECT in wherever you want; you can configure and operate it in the "Smart Home" area of the FRITZ!Box user interface.