FRITZ!WLAN Repeater N/G Service - Knowledge Base
- FRITZ!Box 7590
- FRITZ!Box 7581
- FRITZ!Box 7560
- FRITZ!Box 7530
- FRITZ!Box 7490
- FRITZ!Box 7430
- FRITZ!Box 7390
- FRITZ!Box 7369
- FRITZ!Box 7360
- FRITZ!Box 7340
- FRITZ!Box 7330
- FRITZ!Box 7272
- FRITZ!Box 6890 LTE
- FRITZ!Box 6840 LTE
- FRITZ!Box 6820 LTE
- FRITZ!Box 6810 LTE
- FRITZ!Box 6591 Cable
- FRITZ!Box 6590 Cable
- FRITZ!Box 6490 Cable
- FRITZ!Box 5491
- FRITZ!Box 5490
- FRITZ!Box 4040
- FRITZ!Box 4020
- FRITZ!Box 3490
- FRITZ!Box 3390
- FRITZ!Box 3370
- FRITZ!Box 3272
- FRITZ!WLAN Stick v2
- FRITZ!WLAN Stick AC 860
Error message "Unidentified Network" in the Windows Network and Sharing Center
A computer that is connected to a wireless router (for example the FRITZ!Box) by means of a FRITZ!WLAN Stick cannot access the internet. The computer's "Network and Sharing Center" displays the message "Unidentified Network".
Simply proceed as described below. After each measure, check whether the problem persists.
1 Enabling the wireless router's DHCP server
To ensure that all of the wireless devices connected to the wireless router automatically obtain the correct IP settings, make sure that the router's DHCP server is enabled:
Note:We used a FRITZ!Box as an example for the configuration. If you are using a different wireless router, refer to the device's manufacturer for information on how to set it up, for example consult the manual.
- Click "Home Network" in the FRITZ!Box user interface.
- Click "Network" or "Home Network Overview" in the "Home Network" menu.
- Click on the "Network Settings" tab.
- Click the "IPv4 Addresses" button. If the button is not displayed, enable the Advanced View first.
- Enable the DHCP server and define the range from which the FRITZ!Box assigns IP addresses.
Note:The FRITZ!Box has the IP address 192.168.178.1 (subnet mask 255.255.255.0) and assigns IP addresses from xxx.20 to xxx.200 in the factory settings.
- Click "OK" to save the settings.
2 Configuring a computer to automatically obtain IP settings
To ensure that the computer always uses the correct IP settings, make sure that it automatically obtains its IP settings from the FRITZ!Box (this is the standard setting for most operating systems):
- Configure the computer to automatically obtain IP settings via DHCP.
3 Configuring the computer's firewall
A firewall can interfere with the communication between the computer and the wireless router:
- Configure the firewall so that it allows connections from the computer to the wireless router. Refer to the manufacturer of the firewall for information on how to set it up, for example consult the manual.