FRITZ!Repeater DVB-C Service - Knowledge Base

FRITZ!Repeater DVB-C Service

Loading the FRITZ!Repeater's factory settings

When you load the factory settings, all of the individual settings you have made in the FRITZ!Repeater are deleted. It makes sense to load the factory settings if you are going to use the FRITZ!Repeater at a different location or are planning to pass it on to another user, for example. In addition, this deletes incorrect settings that prevent the FRITZ!Repeater from functioning properly.

  1. Plug the FRITZ!Repeater in.
  2. Wait about 1 minute until the FRITZ!Repeater starts and the "Power" and "WLAN" LEDs remain lit or the LEDs of the signal strength indicator flash.
  3. Push and hold down the "WPS" button down for about 15 seconds until all of the LEDs flash at the same time.

    Fig.: Loading the FRITZ!Repeater factory settings

  4. The "Power" and "WLAN" LEDs remains lit as soon as the factory settings have finished loading.