FRITZ!WLAN Repeater 300E Service - Knowledge Base

FRITZ!WLAN Repeater 300E Service

Forgot password for accessing user interface of FRITZ!WLAN Repeater

The FRITZ!WLAN Repeater password offers you protection from unauthorized access to your FRITZ!WLAN Repeater. If you forget this password, you can no longer access the repeater's settings or functions, and you cannot login to it.

Simply proceed as described below. After each measure, check whether the issue persists.

1 Entering the FRITZ!Box password

If the latest FRITZ!OS is installed on a FRITZ!WLAN Repeater, it takes on the password and, if applicable, the user name of the FRITZ!Box if you did not assign the FRITZ!WLAN Repeater its own password. You can then open the repeater's user interface if you enter the corresponding FRITZ!Box password:

  • Enter the password for the FRITZ!Box.

2 Loading the FRITZ!WLAN Repeater factory settings

If you did not enable the "push service" in your FRITZ!WLAN Repeater or you cannot access the e-mail address you entered, you must load the repeater's factory settings.

Important:When you load the factory settings, all of the settings you made in the FRITZ!WLAN Repeater are deleted.

You can use the "WPS" button to load the FRITZ!WLAN Repeater's factory settings even if you have forgotten your password:

  1. Plug the repeater in.
  2. Wait until the "Power" and "WLAN" LEDs remain lit.
  3. Push and hold the "WPS" button down for about 15 seconds until all of the LEDs flash at the same time.

    Fig.: Loading the FRITZ!WLAN Repeater factory settings

  4. Wait until the factory settings have been completely loaded and both the "Power" and "WLAN" LEDs remain lit.

Note:Configure the "push service" so you will be able to recover your password, should you forget it.