FRITZ!DECT 301 Service - Knowledge Base

FRITZ!DECT 301 Service

Using the FRITZ!DECT radiator control in the FRITZ!Box home network

A FRITZ!DECT radiator control is integrated into the FRITZ!Box home network via an encrypted DECT connection (DECT ULE). Then you can use the FRITZ!Box user interface to set up an individual heating program.

Requirements / Restrictions

  • FRITZ!DECT 301 can only be used with FRITZ!Boxes equipped with DECT base stations, except for FRITZ!Box 7412.
  • A maximum of twelve radiator controls can be registered with the FRITZ!Box.

1 Establishing a DECT connection

  1. Push the "DECT" or the "Fon/DECT" button on your FRITZ!Box. Hold down the button for at least 6 seconds until the "DECT" or "Info" LED on the FRITZ!Box starts to flash. The FRITZ!Box is in registration mode as long as the LED flashes.
  2. Push the "MENU" button on the radiator control within 2 minutes.
  3. Select the menu item "Anmeldung" on the radiator control and then push the "OK" button. The message "Anmeldung war erfolgreich" is shown in the display.

The DECT connection is established as soon as the symbol for the radio connection is shown continuously in the display of the radiator control.

2 Installing FRITZ!DECT on the radiator and adjusting it to valve lift

The radiator control must first be mounted on the radiator and then adjusted to the valve lift of the radiator valve:

  1. Remove the thermostat from the radiator.
  2. If necessary, mount the appropriate adapter.
  3. Mount the radiator control.
  4. Follow the instructions on the display to adjust the radiator control to the valve lift. The valve adjustment is successfully completed as soon as the temperature is shown on the display.

3 Setting up the radiator control

  1. Click "Home Network" or "Smart Home" in the FRITZ!Box user interface.
  2. Click "Smart Home" in the "Home Network" menu or click "Device Management" in the "Smart Home" menu.
  3. Click the (Edit) button for the respective radiator control.
  4. Configure the desired settings.
  5. Enable the option "Push service enabled" so that you receive an email if the battery is low, the radio connection is lost, or there are errors in the radiator control.
  6. Click "OK" to save the settings.

Since radiator controls operate according to the DECT ULE (Ultra Low Energy) standard, they only communicate with the FRITZ!Box at longer intervals to save energy and minimize DECT radiation. As a result, it can take 15 minutes for the settings to be transferred to the radiator control. It can take up to 60 minutes during vacation switching and the phase when the radiator is turned off. To transmit the settings immediately, just push any button on the radiator control.

The radiator control is now configured and you can manually control the heater on the device itself, using the FRITZ!Box interface, with FRITZ!DECT 440, with FRITZ!Fon (menu "Home Network > Smart Home"), over the internet with MyFRITZ!App, or enable it in the home network and over the internet with FRITZ!App Smart Home if you use a FRITZ!Box with FRITZ!OS 7.20 or later.

Smart heating with FRITZ!DECT 301