FRITZ!Box 7590 Service - Knowledge Base

FRITZ!Box 7590 Service
Not your product?
This document is also available for the following products:

Calls to an analog landline number are signaled with a delay

Calls to your analog landline number are signaled with a delay. Callers hear the ringing tone several times before your telephone rings or the "Fixed Line" LED on the FRITZ!Box lights up to signal the call.

Simply proceed as described below. After each measure, check whether the problem is solved.

1 Disabling SMS and MMS support in the telephone

The telephone reacts quicker to calls if you disable SMS and MMS support:

  1. Disable SMS and MMS support in the telephone connected to the FRITZ!Box. Refer to the device's manufacturer for information on how to set it up, for example consult the manual.

2 Having your provider activate CLIP

The FRITZ!Box signals incoming calls with less of a delay if the provider activates CLIP for your line. The following step is only necessary if you do not see the caller ID on the display of your telephone when you receive a call:

  1. Have your telephony provider activate the service "Calling line identification presentation (CLIP)" for your landline.

    ATTENTION!You may be charged for activating it. Ask your telephony provider about charges in advance!

3 Checking if another device is interfering with the FRITZ!Box

A device connected to the FRITZ!Box or the power mains may be transmitting interference to the FRITZ!Box. Perform the following test to see if this is the case:

  1. Remove all devices and cables from the LAN ports and the USB port on the FRITZ!Box. If no devices were connected, connect a computer to a LAN port on the FRITZ!Box.
  2. If the error no longer occurs, then a device connected to the FRITZ!Box was transmitting interference to the FRITZ!Box or the computer now channels it off. Usually, you can eliminate the cause of the interference through one of these measures:
    1. Use a power strip to connect the FRITZ!Box and all of the connected devices to the same electric outlet.
    2. Test different electric outlets and power strips.
    3. Use UTP network cables to connect devices to the LAN ports on the FRITZ!Box. UTP network cables do not have a ground wire and do not transmit interference to the FRITZ!Box, unlike STP network cables such as the one included with delivery.

      Important:If the problem occurs with a FRITZ!Powerline adapter, use the UTP network cable included with the FRITZ!Powerline adapter.

    4. If a device connected to the USB port is transmitting interference to the FRITZ!Box, connect the device to a USB port on your computer instead of to the FRITZ!Box.

If there is still a delay before incoming calls are signaled, the issue is not caused by the FRITZ!Box. Instead, it is caused by a different component (such as a telephone, cable, power supply).