FRITZ!Box 6490 Cable Service - Knowledge Base

FRITZ!Box 6490 Cable Service

Using a debit card reader with the FRITZ!Box

If your debit card reader has a network port or is equipped with wireless LAN (WiFi), you can simply connect it to a LAN port or the wireless network of your FRITZ!Box and use it to read debit cards.

Note:If your debit card reader only has an analog port, you can configure the debit card reader as a telephony device in the FRITZ!Box.

Important:Some of the settings described here are only displayed if the advanced view is enabled in the user interface.

1 Configuring the FRITZ!Box

The FRITZ!Box is configured as a DHCP server in the factory settings. If you disabled the FRITZ!Box's DHCP server, configure the following settings:

  1. Click "Home Network" in the FRITZ!Box user interface.
  2. Click "Home Network Overview" in the "Home Network" menu.
  3. Click on the "Network Settings" tab.
  4. Click the "IPv4 Addresses" button.
  5. Enable the DHCP server and define the range from which the FRITZ!Box assigns IP addresses.

    Note:The FRITZ!Box has the IP address (subnet mask and assigns IP addresses from xxx.20 to xxx.200 in the factory settings.

  6. Click "OK" to save the settings.

2 Configuring a debit card reader

The debit card reader needs specific IP settings in order to communicate with the FRITZ!Box:

  • Configure the debit card reader to automatically obtain IP settings (DHCP client). Refer to the manufacturer for information on how to set it up, for example consult the manual.

3 Connecting the debit card reader to the FRITZ!Box

The debit card reader is now connected to the FRITZ!Box and can be used to read debit cards.

Note:Refer to the manufacturer for further information on how to set up the debit card reader.